Command >> FACTOR

Manual Page for Command >> FACTOR

Syntax
>> FACTOR

Parent Command
> PARAMETER

Subcommand
>>> NONE >>> SET

Description
This command selects as a parameter a constant factor with which the calculated TOUGH2 output will be multiplied. The factor is applied to the output that refers to a specific data set:

z = z_TOUGH2 * factor

where factor is the multiplication factor and z_TOUGH2 is the TOUGH2 output. The result z is compared to the measurement z* of the corresponding data set. This option allows correcting for a systematic, but unknown relative error in the data. The data set is identified by number using command >>> SET (p). If the factor is known and does not need to be estimated, use command >>>> FACTOR (o).

Example
> PARAMETER >> FACTOR >>> SET No. : 1 >>>> ANNOTATION: correct amplitude >>>> GUESS: 1.0 <<<< <<< <<

See Also
>> DRIFT | >> LAG | >> SHIFT | >>> SET (p) | >>>> FACTOR (o)

Back to Command Index

Page updated: July 29, 1997